SHIPWRIGHT with Security Clearance

Duties * You will establish reference point and lines for mooring and drydocking of vessels. * You will fabricate, install, and repair a variety of materials to support the refit of submarines. * You will report to the supervisor on work progress, technical and personnel problems, material, and manpower requirements. * You will maintain overall alignment of submarines and plots reference points and lines. * You will perform a variety of tasks to support work operations while submarine is in drydock. Requirements Conditions of Employment * Must be a US Citizen. * Must be determined suitable for federal employment. * Must participate in the direct deposit pay program. * New employees to the Department of the Navy will be required to successfully pass the E-Verify employment verification check. To learn more about E-Verify, including your rights and responsibilities, visit e-verify.gov * Within the Department of Defense (DoD), the appointment of retired military members within 180 days immediately following retirement date to a civilian position is subject to the provisions of 5 United States Code 3326. * Males born after 12-31-59 must be registered for Selective Service. * You will be required to successfully complete a pre-appointment physical examination. * This is a bargaining unit position. * You will be required to obtain and maintain an interim and/or final security clearance prior to entrance on duty. Failure to obtain and maintain the required level of clearance may result in the withdrawal of a job offer or removal. * This position may require travel from normal duty station to CONUS and OCONUS and may include remote or isolated sites. You must be able to travel on military and commercial aircraft for extended periods of time. * This is a Mission Essential position. You will be required to ensure organization or facility continuity of operations and/or completion of tasks that are considered essential to the mission designated by a local or command decision. * Incumbent may be assigned to any shift, shift hours, any basic workweek, and frequent overtime. * Personnel will be performing tasks at heights requiring the use of fall protection required. Only use within the capacity range of 30 to 300 pounds can quality to utilize fall protection equipment. * This position may require travel world wide at which time additional medical screening may be required. * Must be able to maintain an IT-II level designation. Qualifications Although a specific length of time and experience is not required for most trade and labor occupations, you must show through experience and training that you possess the quality level of knowledge and skill necessary to perform the duties of the position at the level for which you are applying. Qualification requirements emphasis is on quality of experience, not necessarily the length of time. Your qualifications will be evaluated on the basis of your level of knowledge, skills, abilities and/or competencies in the job elements and screen out listed below. This job has a screen-out element which will be used to determine minimum eligibility for this job. Applicants who do not receive a minimum of two points on the screen-out element(s) will be found ineligible. The Screen-out Element for this position is: ABILITY TO DO THE WORK OF THE POSITION WITHOUT MORE THAN NORMAL SUPERVISION. * Ability to build and maintain submarine drydocking equipment. * Ability to read and interpret blueprints, instructions, specifications, and docking worksheets to perform tasks within the shipwright trade. * Ability to fabricate a variety of wooden articles and equipment, including shoring, cribbing, wedges, chart tables, work benches, plaque boards, and other shipwright-related items. * Ability to possess a working knowledge of trade equipment, including transits, theodolites, surveyor's levels, and laser beam equipment. * Ability to build and position cradles, hull blocks, bilge blocks, and other structures used to dry dock vessels. * Ability to construct staging and scaffolding for elevated work, such as sandblasting, painting, and shaft removal. Applicants must meet the requirements of the Office of Personnel Management (OPM) Job Qualification Handbook for Trades and Labor Occupations. Additional qualification information can be found at: https://www.opm.gov/policy-data-oversight/classification-qualifications/federal-wage-system-qualifications/#url=List-of-Approved-Job-Elements Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., professional, philanthropic, religious, spiritual, community, student, social). Volunteer work helps build critical competencies, knowledge, and skills and can provide valuable training and experience that translates directly to paid employment. Additional information This position is covered by the Department of Defense Priority Placement Program. Additional vacancies may be filled by this announcement. This position is subject to work an uncommon tour, including nights, weekends, and holidays to meet mission requirements. Overtime or night differential pay and/or unusual duty hours may be required. A tentative offer of employment will be rescinded if the selectee fails to meet the pre-employment requirements, including failure to report to any of the scheduled appointments. During the application process you will have the option to opt-in to make your resume available to hiring managers in the agency who have similar positions. Opting in does not impact your application for this announcement, nor does it guarantee further consideration for additional positions. Federal annuitant information: The selection of an annuitant is subject to the Department of Defense and Department of the Navy policy on the employment of annuitants. Policy information may be found at: http://www.secnav.navy.mil/donhr/Documents/CivilianJobs/FedCivAnnuitants.pdf PPP applicants will be placed at the FPL, if determined Well Qualified (WQ). To receive priority consideration, the FPL must be the same grade level or equivalent of the retained grade or the grade held immediately prior to separation. ICTAP Applicants: To be considered well-qualified and exercise selection priority as an ICTAP candidate, displaced Federal employees must satisfy all qualification requirements for the position and receive a rating in the highly qualified category (score 85) or higher. ICTAP candidates must provide copies of all of the following documentation at the time of application: 1) agency notice; 2) most recent performance appraisal; and 3) most recent SF-50 or notification of personnel action that includes position, grade level, and duty location. Applicants who do not provide this documentation will not receive consideration as an ICTAP candidate. For more information about ICTAP eligibility please review the following link: https://www.usajobs.gov/Help/working-in-government/unique-hiring-paths/federal-employees/career-transition/ Military Spouse Preference applicants will be placed at the highest grade for which they have applied and are determined Best Qualified (BQ). A BQ military spouse possesses knowledge, skills, abilities, and competencies comparable to others who meet the competitive referral criteria for the specific position. Certain incentives (such as Recruitment, Relocation or Student Loan Repayment) may be authorized to eligible selectees. A relocation incentive is generally a single payment intended to offset some of the relocation costs experienced by the selectee. A relocation incentive may be authorized. How You Will Be Evaluated You will be evaluated for this job based on how well you meet the qualifications above. In order to qualify for this position, your resume must provide sufficient experience and/or education, knowledge, skills, and abilities, to perform the duties of the specific position for which you are being considered. Your resume is the key means we have for evaluating your skills, knowledge, and abilities, as they relate to this position. Therefore, we encourage you to be clear and specific when describing your experience. When the application process is complete, we will review your resume to ensure you meet the hiring eligibility and qualification requirements listed in this announcement. You will be rated based on the information provided in your resume and responses to the Occupational Questionnaire, along with your supporting documentation to determine your ability to demonstrate the following job elements: * ABILITY TO DO THE WORK OF THE POSITION WITHOUT MORE THAN NORMAL SUPERVISION
* INGENUITY (ABILITY TO SUGGEST AND APPLY NEW METHODS)
* KNOWLEDGE OF MATERIALS
* TECHNICAL PRACTICES (THEORETICAL, PRECISE, ARTISTIC) You should list any relevant performance appraisals and incentive awards in your resume as that information may be taken into consideration during the selection process. If selected, you may be required to provide supporting documentation. If after reviewing your resume and supporting documentation, a determination is made that you inflated your qualifications and/or experience, your score may be adjusted to more accurately reflect your abilities or you may be found ineligible/not qualified. Please follow all instructions carefully. Errors or omissions may affect your rating or consideration for employment. All eligibility and qualification requirements must be met by the closing date of this announcement. Required Documents You are required to provide documentation that supports the eligibility and qualification claims made in your resume and assessment questionnaire. You must submit the applicable documents listed here and those listed with the eligibilities you select in the announcement questionnaire with your application package. Applicants who do not provide supporting documentation that fully support their claims will not be referred to the hiring manager. Cover letter is optional. A complete